Ready set of radio relays is designed for remote switching of electrical circuits with currents up to 250V/10A, such as gates, elevators, small heaters, starters, electric locks. Ideal for embedding in a car system, as it can be powered by 12V. Included is a protective box-case with latches.
Pressing the button on the key fob turns on the relay. Since the contacts NC, NO, COM of the switching contact of the relay are output, connecting to the desired contact can both close and open the circuit. The range is up to 50m, indoors up to 15m, depending on the "noise" of the radio and weather conditions.
Key Features:
-
Model: AK-RK01-12
-
Switching current: ≤10A/250V AC , ≤10A/30V DC
-
Supply voltage: DC 9-14V
-
Operating frequency: 315MHz
-
Receiver sensitivity: >-105 dB
-
Number of channels: 1
The receiver module can operate in several modes: momentary, hold and latch.
1. Momentary - the relay is switched while the button on the remote control is held down.
Jumper position: no contact closed.
2. Hold - the first time you press the button on the remote control, the relay switches. When the same button is pressed a second time, the relay returns to its original position.
Jumper position: 2+3
3. Latch - when you press one button on the remote control, the relay switches, when you press another button, the relay goes into its original state. This mode requires an optional multi-button remote control.
Jumper position: 1+2.
To add a remote control, you need to briefly press the button on the module, the LED will go out, and press the button on the remote control. The remote control will remain in memory. Supports multiple remotes at the same time.
To erase all remotes from the device memory, you need to press and hold the button on the module for 10 seconds, the LED will go out, after 10 seconds it will light up, all remotes are erased.
You can use remotes with encoders PT2260, eV1527 and their analogues.